SOLE SOURCE REPAIRS, UPGRADE, REWORK, MAINTENACE, SPARES, ENGINEERING AND LOGISTICS SUPPORT SERVICES, TEST AND EVALUATION, REDESIGN AND MODIFICATION, TRAINING SUPPORT, DATA COLLECTION
N00164-18-R-JV24 - SOLE SOURCE - REPAIRS, UPGRADE, REWORK, MAINTENACE, SPARES, ENGINEERING AND LOGISTICS SUPPORT SERVICES, TEST AND EVALUATION, REDESIGN AND MODIFICATION, TRAINING SUPPORT, DATA COLLECTION - FSC 5895 - NAICS 334511
Issue Date: 17 NOV 2017 - Closing Date: 04 JAN 2018 - 2:00 PM EST
A Solicitation will NOT be posted to Fed Biz Opps due to its sole source nature. The draft agreement will be issued directly to DB Controls Corporation on 15 January 2018.
SOLE SOURCE PROCUREMENT - Naval Surface Warfare Center (NSWC) Crane has a requirement to award a five-year Basic Ordering Agreement (BOA) for Repair, Upgrade, Rework and Maintenance, Spares and Replenishment, Engineering Support Services, Test and Evaluation, Redesign and Modification, System Training Support, Data Collection, Logistics Support Services, as required. This requirement is in support of a Multi-Mission system used on manned platforms in support of the Maritime Patrol and Reconnaissance Aircraft (MPRA) Program Office PMA-290. Services and support actions consisting of, but not limited to spares, repair actions, calibration, assembly modification, design upgrades, depot piece-part lay-in, engineering support, training services, hardware and software support, and system related logistics services of the Traveling Wave Tube Amplifier (TWTA) utilized in a Multi-Mission System. Job Orders shall be within scope, issued within ordering period, and be within the maximum total dollar value of approximately $13,500,000 over a five-year period. Each Job Order will be synopsized.
The proposed Agreement is for the supplies and services for which the Government intends to solicit and negotiate with one source, DB Control, 1120 Auburn St, Fremont, CA 94538-7328, under authority of FAR 6.302-1 (statutory authority 10 U.S.C. 2304(c)(1)), only one responsible source. The basis for restricting competition is the lack of sufficient technical data and duplicative cost to the Government that is not expected to be recovered through competition, and the unacceptable delays in fulfilling the agency requirement through any other source. The duplicative cost and delay are comprised from the cost to procure, re-tool, reverse engineer, generate acceptance test procedures, perform first article testing, acquire flight certification, underway for sub-surface platforms, and perform stress analysis, which would take a minimum of three to five years for development, production, and verification.
All responsible sources may submit a capability statement, proposal, or quotation, which shall be considered by the agency. However, a determination by the Government not to compete this proposed action based upon responses to this draft agreement is solely within the discretion of the Government. Information received will normally be considered solely for the purpose of determining whether to conduct a competitive procurement. Companies interested in subcontracting opportunities should contact DB Controls Corporation directly.
Contractors must be properly registered in the System for Award Management (SAM). Offerors may obtain information on SAM registration and annual confirmation requirements by calling 1-866-606-8220 or via the internet at https://www.sam.gov.
The anticipated Agreement award date is Fourth Quarter Fiscal Year Eighteen (18). A Solicitation will NOT be posted to Fed Biz Opps due to the sole source nature of the action. The draft Agreement will be issued directly to DB Controls Corporation by 15 January 2018.
The point of contact at NSWC Crane is Mr. Seth Taylor, Code 0233, at telephone (812) 854-1324 or e-mail: seth.t.taylor@navy.mil. The mailing address is: Mr. Seth Taylor, Code 0233, Bldg. 3373 Room 223C106, NAVSURFWARCENDIV Crane, 300 Highway 361, Crane, IN 47522-5001. Reference the above number when responding to this notice.
Seth Taylor, Phone 812-854-1324, Email seth.t.taylor@navy.mil
