Pedestal Enclosure
This requirement is for a Hi-Density Pedestal measuring H50" x W30"x L28" made up of 12-14 gauge steel with a 3/4 inch plywood board mounted inside to mount/anchor communications equipment. The pedestal needs to be able to mount to the ground and include a fan to cool communication equipment and needs to run off of 115VAC. The pedestal needs to be modified on one side of the box centered halfway up with a 2" 90 degree conduit elbow to allow for running cable from the box. The conduit needs to be sealed as to not allow weather to enter the box. The bottom of the pedestal needs to be open to run conduit up into the box with no restrictions. Items for this acquisition are requested on a or equal basis.
1. Part#8806-1440-01
H50" x W30" x L28" EMPTY HI-DEN PEDESTAL 28" DEPTH w/ MOUNTING STAKES
3 EA
2. Part#RLH-PAD4854
48" x 54" POLYMER PAD
3 EA
3. Part# RLH-EFKACST-01
EXHAUST FAN w/ THERMOSTAT 115VAC POWER
3 EA
4. Part#RLH-PARTS
2" CONDUIT LB FITTING
3 EA
5. Part# S107
LABOR TO FACTORY MODIFY PEDESTAL FOR FAN AND CONDUIT FITTING
1 EA
Replies maybe submitted via e-mail to [email protected],
Contracting Office Address:
321 Cullen St
Bldg 216
Shaw AFB, South Carolina 29152-5004
Place of Performance:
20 CONS/LGCAB
321 Cullen ST
Shaw AFB, South Carolina 29152
United States
Primary Point of Contact:
A1C Christian Hull
Contract Specialist
[email protected]
Phone: 803-895-5623
Fax: 803-895-5339
Christian Hull, Phone 8038955623, Email [email protected]
