PALISADES DOMESTIC WATER SYSTEM
This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in FAR Subpart 12.6, as supplemented with additional information included in this notice. The solicitation number is 0040426796 and is issued as an invitation for bids (IFB), unless otherwise indicated herein. The solicitation document and incorporated provisions and clauses are those in effect through Federal Acquisition Circular 2005-101. The associated North American Industrial Classification System (NAICS) code for this procurement is 333996 with a small business size standard of 500.00 employees. This requirement is a [ Small Business ] set-aside and only qualified offerors may submit bids. The solicitation pricing on www.FedBid.com will start on the date this solicitation is posted and will end on 2019-03-26 17:00:00.0 Eastern Time or as otherwise displayed at www.FedBid.com. FOB Destination shall be IRWIN, ID 83428The DOI BOR Grand Coulee Power Office requires the following items, Meet or Exceed, to the following: LI 001: 3HP VERTICAL TURBINE SUBMERSIBLE PUMP AND MOTOR, 1-1/4 INCH NPT DISCHARGE; 310 TOTAL DISCHARGE HEAD FT; 25 GALLON PER MINUTE; 220 VOLTS ALTERNATING CURRENT (AC) SINGLE PHASE; WITH VARABLE FREQUENCY DRIVE; 0-60 HZ CAPABLE OF 80 HZ OPERATION; IN NEMA 3R PANEL AND PRESSURE TRANSDUCER; 4 TO 20 MILLIAMP; 1/4 INCH NPT THREAD., 6, EA;LI 002: 6 INCH CARBON STEEL WELL CASING, MINIMUM 10 GAUGE, 20 FOOT LENGTHS, SQUARE CUT., 900, FT;LI 003: 6 INCH STAINLESS STEEL WELL SCREEN 5 FOOT WITH 5 INCH X 6 INCH K-PACKER SEAL IN M (5"X6") WELD ON., 6, EA;LI 004: 1-1/4 INCH NPT BRASS INLINE CHECK VALVE, 250# WOG WITH BRIDGE WALL MARKING., 6, EA;LI 005: 1-1/4 INCH NPT, SCHEDULE 40 GALVANIZED THREADED AND COUPLED PIPE (DROP PIPE) 21 FOOT LENGTHS., 48, EA;LI 006: RV ELECTRICAL PEDESTAL BACK TO BACK, 50, 30, 120 SFCI OUTLETS SINGLE PHASE 240 VAC, DUAL 3/4 INCH HOSE BIB, WITH METER BASE AND METER, PAD MOUNT., 3, EA;LI 007: STAINLESS STEEL PRESSURE WATER TANK. BLADDER TYPE, PRE-CHARGED HYDROPNEUMATIC TANK DESIGNED FOR RESIDENTIAL AND COMMERCIAL WATER WELL, BOOSTER AND IRRIGATION SYSTEM. STAINLESS STEEL SHELL, BUTYL RUBBER AIR CELL DIAPHRAGM, STAINLESS STEEL CONNECTION. MAX WORKING PRESSURE 125 PSI, MAX WORKING TEMP 140 DEGREES F, PRE-CHARGE ADJUSTABLE PSI 38. VOLUME: 4 GALLON. DIAMETER: NTE 4-1/2 INCH, LENGTH 72 INCH., 6, EA;LI 008: BENTONITE 75 YARDS. 3/8 INCH BENTONITE CHIP IN 1/34 YARD TOTES., 75, EA;LI 009: BENTONITE 7 YARDS. BENTONITE POWDER IN 50 LB BAGS OR 1/34 YARD TOTES., 7, EA;Solicitation and Buy Attachments***Question Submission: Interested offerors must submit any questions concerning the solicitation at the earliest time possible to enable the Buyer to respond. Questions must be submitted by using the 'Submit a Question' feature at www.fedbid.com. Questions not received within a reasonable time prior to close of the solicitation may not be considered.***For this solicitation, DOI BOR Grand Coulee Power Office intends to conduct an online competitive reverse auction to be facilitated by the third-party reverse auction provider, FedBid, Inc. FedBid has developed an online, anonymous, browser based application to conduct the reverse auction. An Offeror may submit a series of pricing bids, which descend in price during the specified period of time for the aforementioned reverse auction. DOI BOR Grand Coulee Power Office is taking this action in an effort to improve both vendor access and awareness of requests and the agency's ability to gather multiple, competed, real-time bids. All responsible Offerors that respond to this solicitation MUST submit the pricing portion of their bid using the online exchange located at www.FedBid.com. There is no cost to register, review procurement data or make a bid on www.FedBid.com. Offerors that are not currently registered to use www.FedBid.com should proceed to www.FedBid.com to complete their free registration. Offerors that require special considerations or assistance may contact the FedBid Helpdesk at 877-9FEDBID (877-933-3243) or via email at marketplacesupport@unisonglobal.com. Offerors may not artificially manipulate the price of a transaction on www.FedBid.com by any means. It is unacceptable to place bad faith bids, to use decoys in the www.FedBid.com process or to collude with the intent or effect of hampering the competitive www.FedBid.com process. Should offerors require additional clarification, notify the point of contact or FedBid at 877-9FEDBID (877-933-3243) or marketplacesupport@unisonglobal.com.Use of FedBid: Buyers and Sellers agree to conduct this transaction through FedBid in compliance with the FedBid Terms of Use. Failure to comply with the below terms and conditions may result in offer being determined as non-responsive.New Equipment ONLY; NO remanufactured or "gray market" items. All items must be covered by the manufacturer's warranty.Bid MUST be good for 30 calendar days after close of Buy.Shipping must be free on board (FOB) destination CONUS (Continental U.S.), which means that the seller must deliver the goods on its conveyance at the destination specified by the buyer, and the seller is responsible for the cost of shipping and risk of loss prior to actual delivery at the specified destination.This solicitation requires registration with the System for Award Management (SAM) in order to be considered for award, pursuant to applicable regulations and guidelines. Registration information can be found at www.sam.gov. Registration must be "ACTIVE" at the time of award.SEE ATTACHED CLAUSESPer FAR Clause 52.211-6, Brand Name or Equal, if quoting other than specified, you MUST attach enough literature, including pictures and specifications, for our evaluation team to determine if it meets the criteria to be considered acceptable as a replacement.The Contractor must use the IPP website to register access and use IPP for submitting requests for payment. The Contractor Government Business Point of Contact (as listed in SAM) will receive enrollment instructions via email from the Federal Reserve Bank of Boston (FRBB) within 3-5 business days of the contract award date. Contractor assistance with enrollment can be obtained by contacting the IPP Production Helpdesk via email ippgroup@bos.frb.org or phone (866) 973-3131.Per FAR Part 19.102(F)(1) - The Non-Manufacturer Rule applies to this acquisition. Any product supplied under this solicitation shall be manufactured by a small business.
Name: Client Services, Title: Client Services, Phone: 1.877.933.3243, Fax: 703.422.7822, Email: Clientservices@fedbid.com;
