External Power Connector
Amendment 01: Please see the questions below that were submitted along with the answers:
1.Regarding specific connector requirements: 3) The connector shall have the ability to survive Soldier and Vehicle environments operational and storage - refer to MIL-STD-810." - Are there specific requirements within MIL-STD-810 to be applied?
PM Response: The attached file can be used as minimum requirements. Please see attachment labeled "Nett Warrior Connectors Specification".
2. Is there an IP rating requirement, and is that requirement applicable in the mated condition only or also in the unmated condition?
PM Response: Minimum rating would be IP67 mated and unmated.
3. Regarding the desire to have "Bulkhead features option", would that be a panel-mount or flat-mount? Would it also need to mount to a molle loop, or be affixed to a garment?
PM Response: The primary use for the connector will be to mount to/through MOLLE Loops without modification to the load carriage system fabric (i.e. Not sewn in). The secondary use could see the connector being mounted to the surface of a module/components of Soldier kit.
Kristin L. Anderson, Purchasing Agent, Email kristin.l.anderson24.civ@mail.mil
